As a Honda Accord 2018 owner, it’s important to keep your vehicle in top condition to ensure it runs smoothly and safely. Regular maintenance, including oil changes, tire rotations, and fluid checks, can help keep your Honda Accord 2018 in top condition. However, there are some specific B17 maintenance items you should keep in mind.
In this article, we’ll provide a step-by-step guide on B17 Maintenance for Honda Accord 2018 to help you keep your Honda Accord 2018 in tip-top shape.
There are some specific B17 Maintenance For Honda Accord 2018 items you should keep in mind:
- Engine Air Filter
- Engine Oil
- Transmission Fluid
- Brake Fluid
Engine Air Filter
The engine air filter is an important component that helps keep the engine clean and running smoothly. Every 15,000 miles or once a year, whichever comes first, Honda suggests replacing the engine air filter.
Here’s how to replace the engine air filter in your Honda Accord 2018:
Step 1: Locate the air filter box. It’s usually located in the engine compartment, near the battery or the radiator.
Step 2: Open the air filter box. This is typically done by removing the clips or screws that secure the box in place.
Step 3: Remove the old air filter. Take out the old air filter and inspect it for any signs of damage or wear.
Step 4: Replace the air filter with a new one. Make sure the new air filter is installed correctly and securely.
Step 5: Close the air filter box and secure it with the clips or screws.
Engine Oil
Regular oil changes are crucial for maintaining the health of your Honda Accord 2018 engine. Every 15,000 miles or once a year, whichever comes first, Honda suggests replacing the engine air filter. Oil changes are advised by Honda to be performed every 7,500 miles or every six months, whichever occurs first.
The following steps will guide you through changing the oil in your 2018 Honda Accord:
Step 1:
Collect all of the required instruments and supplies. A container of the appropriate oil for your vehicle, an oil filter wrench, a drain pan, and a replacement oil filter are all things that you will need in order to change the oil in your vehicle.
Step 2:
Start the car and let it warm up. Turn the key to start the vehicle, and then give it a few minutes to run so that the oil can reach operating temperature. Because of this, draining the old oil will be much simpler.
Step 3:
Find the plug that allows oil to drain. On the underside of the engine block, close to the oil pan, is where the plug for draining oil can be found.
Step 4:
Put the drain pan in place directly below the drain plug. Using the oil filter wrench, take out the drain plug, and then tilt the pan so that the used oil can run off into it.
Step 5:
Replace the drain plug and install the new oil filter. Make sure the new oil filter is installed correctly and securely.
Step 6:
Fill the engine with new oil. Pour in the recommended amount of oil, making sure not to overfill.
Step 7:
Make sure the oil level is correct. Turn the key to start the engine, and then give it a few minutes to warm up. The dipstick should then be used to check the level of oil in the engine, and additional oil should be added if necessary.
Transmission Fluid
The transmission fluid helps to maintain the transmission’s smooth operation and protects it from the wear and tear that comes with normal use. Transmission fluid should be changed every 60,000 miles or 48 months, whichever comes first, and checked on a regular basis.
Here’s how to check and change the transmission fluid in your Honda Accord 2018:
Step 1: Locate the transmission fluid dipstick. The dipstick is usually located near the engine, and it will have a yellow or orange handle.
Step 2: Remove the dipstick and check the fluid level. The fluid should be at the full mark on the dipstick. If it’s low, add more fluid until it reaches the full mark.
Step 3: Change the transmission fluid. To change the transmission fluid, you’ll need a drain pan, a new transmission filter, and a container of the correct transmission fluid for your Honda Accord 2018.
Step 4: Locate the transmission drain plug. The drain plug is located on the bottom of the transmission pan.
Step 5: Place the drain pan under the drain plug. Remove the drain plug and allow the old fluid to drain into the pan.
Step 6: Replace the drain plug and install the new transmission filter. Make sure the new filter is installed correctly and securely.
Step 7: Fill the transmission with new fluid. Pour in the recommended amount of fluid, making sure not to overfill.
Step 8: Check the fluid level. With the engine running, check the fluid level with the dipstick and add more fluid if necessary.
Brake Fluid
Brake fluid is essential for the proper operation of your vehicle’s braking system. Honda recommends checking the brake fluid level every 6 months and changing the fluid every 2 years. Here’s how to check and change the brake fluid in your Honda Accord 2018:
Step 1: Locate the brake fluid reservoir. The brake fluid reservoir is usually located near the engine and will have a cap labeled “Brake Fluid.”
Step 2: Check the fluid level. The fluid level should be at the full mark on the side of the reservoir. If it’s low, add more fluid until it reaches the full mark.
Step 3: Change the brake fluid. To change the brake fluid, you’ll need a container of the correct brake fluid for your Honda Accord 2018 and a turkey baster or similar tool.
Step 4: Remove the cap from the brake fluid reservoir. Use the turkey baster to remove as much of the old fluid as possible.
Step 5: Fill the reservoir with new fluid. Fill the reservoir with the recommended amount of new brake fluid.
Step 6: Check for leaks. After changing the fluid, inspect the brake system for any leaks. If there are leaks, have them repaired immediately.
You can also watch a video on B17 maintenance honda accord 2018:
What Is B17 Maintenance On Honda Accord 2018?
A comprehensive service routine is included in the B17 maintenance code for a Honda Accord 2018. This service usually consists of a thorough vehicle inspection, engine oil change, tire rotation, and brake fluid flushing.
This combination of tasks ensures that your vehicle is in good working order while also addressing key areas of concern. A B17 service costs around $200 at most Honda dealerships and repair shops.
What Is Routine Maintenance On A Honda Accord?
A Honda Accord’s routine maintenance includes periodic service intervals of 5,000 to 7,500 miles. Your Accord will receive new engine oil and an oil filter during these visits. Furthermore, fluids such as transmission, power steering, windshield wiper, and coolant will be inspected.
A quick tire inspection will be performed to ensure that they are in good condition. This routine maintenance program keeps your Honda Accord running smoothly and prevents potential problems.
What Is The Difference Between Honda Service A And B?
Honda’s maintenance schedule includes Services A and B. Service A typically entails changing the engine oil and, in some cases, the oil filter. Service B, which applies to all Honda vehicles, includes changing the engine oil and filter, inspecting the front and rear brakes, and checking the parking brake adjustment.
As part of these maintenance routines, your Honda model may require additional inspections or services. These services are critical for keeping your Honda vehicle in top shape and extending its lifespan.
Conclusion
Maintaining your Honda Accord 2018 is essential to ensure its longevity and performance. By performing regular checks and replacements of the engine oil, air filter, transmission fluid, and brake fluid, you can keep your vehicle running smoothly and avoid any costly repairs.
By taking good care of your Honda Accord 2018, you’ll be able to enjoy a reliable and comfortable driving experience for years to come.
Also Read:
- Honda Accord Speakers Not Working
- 2005 Honda Accord Engine Swap Compatibility
- Honda Accord Aux Not Working
- Honda Accord Traction Control Won’t Turn Off
